Custom Cornhole boards for a Client

I had been asked to do some custom designs for a client and their game boards of Cornhole.  I presented my client with around ~12ish designs.  There was a large variety ranging from, making the boards look like the green of a golf course, to an inter-dimensional black hole.

Created a stencil and made sure that it fit over the boards the way I measured.  The design was based on the measurements I had taken from the boards, 2'X4' and so the design was scaled down 4"X8".

(I decided to make artsy photos of my processes)
Tried spray paint but wasn't getting the right consistency.  I would end up using up too much spray paint, so I decided to go with black and white paint.

I painted one board all black and one all white.  I then used the stencil and switched colors.  The stencil wasn't a bad idea, after finishing the images, I liked the graphic clean design better than going over with an airbrush to get the shadows.  I made sure my client was OK with the finalized design and proceeded to touch up the sides.

Of course I had to test the boards to make sure the bean bags slide as they needed.

Project took only a day to figure out the stencil and get it painted.